TUSB2136 datasheet(48/53 Pages) TI

部品番号	TUSB2136

部品情報	Universal Serial Bus Compound Hub with General Purpose 8052 MCU

PDF	53 Pages

Scroll/Zoom	100%

メーカー	TI [Texas Instruments]

ホームページ	http://www.ti.com

Logo

48 / 53 page

4−3

15 k

Ω

D+

D−

DP1

DM1

15 k

Ω

5 V

GND

To Power Switch

Figure 4−5. Downstream Connection − Only One Port Shown

4.2

Reset Timing

There are two requirements for the reset signal timing. First, the reset window should be between 100

ms and 10 ms.

At power up, this time is measured from the time the power ramps up to 90% of the nominal VCC until the reset signal

goes high (above 1.2 V). The second requirement is that the clock has to be valid during the last 60

ms of the reset

window. These two requirements are depicted in Figure 4−6. Notice that when using a 12-MHz crystal or the 48-MHz

oscillator, the clock signal may take several milliseconds to ramp up and become valid after power up. Therefore, the

reset window may need to be elongated up to 10 ms to ensure that there is a 60-

ms overlap with a valid clock.

CLK

RESET

VCC

90%

3.3 V

1.2 V

0 V

>60

µs

100

µs < RESET TIME < 10 ms

Figure 4−6. Reset Timing

TUSB2136 データシート(PDF) 48 Page - Texas Instruments

TUSB2136 データシート(HTML) 48 Page - Texas Instruments

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53

データシートダウンロード