CSB10 datasheet(7/12 Pages) CLARKE

部品番号	CSB10

部品情報	SIPHON FEED SANDBLASTER

PDF	12 Pages

Scroll/Zoom	100%

メーカー	CLARKE [Clarke International]

ホームページ	https://www.clarkeinternational.com/

Logo

7 / 12 page

6. Place the upper handle onto the

top of the lower handle/axle

assembly as shown and use 1 long

bolt, 1 washer and 1 nut to lock it

into place.

7. Place a jubilee clip onto each

end of the hose.

8. Firmly push the end of the hose

onto the abrasive inlet on the

sandblasting gun.

9. Slide one of the jubilee clips so

that it is overlapping both the

hose and the abrasive inlet of the

sandblasting gun.

10. Tighten the jubilee clip with a

screwdriver.

11. Firmly push the opposite end of

the hose onto the abrasive outlet,

located at the base of the drum.

NOTE: there is an air hole in the

abrasive outlet - do not

cover this air hole with

abrasive hose.

12. Position the remaining jubilie clip

so that it is overlapping both the

hose and the abrasive outlet of

the drum.

13. Tighten the jubilee clip with a screwdriver.

CSB10 データシート(PDF) 7 Page - Clarke International