STP16DP05

Detection mode functionality

17/29

7.2

Phase two: “error detection”

The 16 data bits must be set “1“ in order to set ON all the outputs during the detection. The

data are latched by LE/DM1 and after that the outputs are ready for the detection process.

When the Micro controller switches the OE\DM2 to LOW, the device drives the LEDs in

order to analyze if an OPEN or SHORT condition has occurred.

The LEDs status will be detected at least in 1 microsecond and after this time the

microcontroller sets OE\DM2 in HIGH state and the output data detection result will go to

the microprocessor via SDO.

Detection mode and normal mode use both the same format data. As soon as all the

detection data bits are available on the serial line, the device may go back to normal mode

of operation. To re-detect the status the device must go back in normal mode and re-

entering in error detection mode .

Figure 16. Detection diagram