BP 104 FASR

16 Version 1.3 | 2018-05-30

Glossary

1)

Testing temperature: T

A = 25°C

2)

Typical Values: Due to the special conditions of the manufacturing processes of LED, the typical data

or calculated correlations of technical parameters can only reflect statistical figures. These do not nec-

essarily correspond to the actual parameters of each single product, which could differ from the typical

data and calculated correlations or the typical characteristic line. If requested, e.g. because of technical

improvements, these typ. data will be changed without any further notice.

3)

Tolerance of Measure: Unless otherwise noted in drawing, tolerances are specified with ±0.1 and

dimensions are specified in mm.

4)

Tape and Reel: All dimensions and tolerances are specified acc. IEC 60286-3 and specified in mm.