21

SPE-11-8-40-J

www.taoglas.com

The GLA.01 can be assembled by following the recommended soldering temperatures are as follows:

*Temperatures listed within a tolerance of +/- 10º C

Smaller components are typically mounted on the first pass, however, we do advise mounting the GLA.01

when placing larger components on the board during subsequent reflows.

Note: Soldering flux classified ROL0 under IPC J-STD-004 is recommended.

8.

Soldering Conditions

6.

Packaging5.

Mechanical Drawing

6.

Packaging

7.

Application Note6. Packaging5.

Mechanical

Drawing

6.

Packaging5.

Mechanical Drawing

6.

Packaging

7.

Application Note6. Packaging

7.

Application Note

7.

Application Note6. Packaging

7.

Application Note6. Packaging5.

Mechanical

Drawing

6.

Packaging5.

Mechanical Drawing