| データシートサーチシステム |
|
DLP-232PC データシート(PDF) 7 Page - THAT Corporation All rights reserved. |
|
|
|||||||||||||||||||||||||||||
DLP-232PC データシート(HTML) 7 Page - THAT Corporation All rights reserved. |
|
7 / 20 page ![]() THAT 626x DEMO Datasheet Page 7 of 20 Document 600194 Rev 00 THAT Corporation; 45 Sumner Street; Milford, MA 01757-1656; USA Tel: +1 508 478 9200; Fax: +1 508 478 0990; Web: www.thatcorp.com Copyright © 2018, THAT Corporation; All rights reserved Download the latest Demo Board GUI software from the THAT Corporation web site. Double click the MicPre.exe icon and the Digitally Controlled Mic Preamp Demo Board Selector will appear. Select the THAT626x from the drop-down menu. The 626x GUI should appear: Next, select the appropriate 626x controller for your demo board, THAT6261, THAT6263, or THAT6266, from the Device drop-down menu depending on which module you have installed into the motherboard Be sure to select the correct device; the structure of the software gain command word is different for each version of the part. The 626x will still operate safely if the wrong device is selected, but the device gain will not be as expected from the indication on the GUI. If the GUI fails to recognize the demo board (most likely caused by a missing USB connection) you will see the following error message: If this message appears, you can click OK and the GUI will open, but there will be no connection to the demo board. Once the source of the problem has been resolved (i.e. Turn on the power or connect the missing USB cable), use the Port=>Reconnect pull down to establish communications. The Port=>Reconnect pull down can be used anytime to reestablish the USB link between the GUI and demo board. Power-on Reset: The 626x’s internal reset is initiated when the 3.3 V logic supply falls below about 0.6V. This 3.3 V logic supply is derived on the demo board from the +5 V supply via an on-board regulator. If the +5 V supply is removed, please insure that the 3.3 V on-board supply has enough time to discharge to below this 1.2 V reset threshold before re-applying the +5 V supply, otherwise the part may power up in an unspeci- fied condition. One final note; if the channel is not passing audio as expected, verify that the “enable” check box is selected, and that the “Mute” check box is NOT selected. Also, make sure that you have the correct device (6261, 6263, or 6266) selected from the “Device” drop-down menu. Software Set-up and Operation |
|
|
リンク URL |
| ALLDATASHEETはお客様のビジネスに役立ちますか? [ DONATE ] |
Alldatasheetは | 広告 | お問い合わせ | プライバシーポリシー | データシートへのリンク | リンク交換 | メーカーリスト All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |