M48T58-70MH1FE datasheet(9/31 Pages) STMICROELECTRONICS

9 / 31 page

M48T58, M48T58Y

Read mode

9/31

Read mode

The M48T58/Y is in the READ Mode whenever W (WRITE Enable) is high, E1 (Chip Enable

1) is low, and E2 (Chip Enable 2) is high. The unique address specified by the 13 Address

Inputs defines which one of the 8,192 bytes of data is to be accessed. Valid data will be

available at the Data I/O pins within Address Access time (tAVQV) after the last address input

signal is stable, providing that the E1, E2, and G access times are also satisfied. If the E1,

E2 and G access times are not met, valid data will be available after the latter of the Chip

Enable Access times (tE1LQV or tE2HQV) or Output Enable Access time (tGLQV).

The state of the eight three-state Data I/O signals is controlled by E1, E2 and G. If the

outputs are activated before tAVQV, the data lines will be driven to an indeterminate state

until tAVQV. If the Address Inputs are changed while E1, E2 and G remain active, output data

will remain valid for Output Data Hold time (tAXQX) but will go indeterminate until the next

Address Access.

Figure 5.

Read mode AC waveforms

Note:

WRITE Enable (W) = High.

AI00962

tAVAV

tAVQV

tAXQX

tE1LQV

tE1LQX

tE1HQZ

tGLQV

tGLQX

tGHQZ

VALID

A0-A12

DQ0-DQ7

tE2HQV

tE2HQX

VALID

tE2LQZ

M48T58-70MH1FE データシート(PDF) 9 Page - STMicroelectronics

M48T58-70MH1FE データシート(HTML) 9 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31

データシートダウンロード