9

0360L–EPROM–12/07

AT27C080

18. Rapid Programming Algorithm

A 50 µs CE pulse width is used to program. The address is set to the first location. V

raised to 6.5V and OE/V

50 µs CE pulse without verification. Then a verification reprogramming loop is executed for

each address. In the event a byte fails to pass verification, up to 10 successive 50 µs pulses

are applied with a verification after each pulse. If the byte fails to verify after 10 pulses have

been applied, the part is considered failed. After the byte verifies properly, the next address is

selected until all have been checked. OE/V

are read again and compared with the original data to determine if the device passes or fails.