ACT11008 datasheet(2/5 Pages) TI

2 / 5 page

74ACT11008

QUADRUPLE 2-INPUT POSITIVE-AND GATE

SCAS013C – AUGUST 1987 – REVISED APRIL 1996

POST OFFICE BOX 655303

• DALLAS, TEXAS 75265

absolute maximum ratings over operating free-air temperature range (unless otherwise noted)†

Supply voltage range, VCC

–0.5 V to 6 V

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Input voltage range, VI (see Note 1)

–0.5 V to VCC + 0.5 V

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Output voltage range, VO (see Note 1)

–0.5 V to VCC + 0.5 V

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Input clamp current, IIK (VI < 0 or VI > VCC)

±20 mA

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Output clamp current, IOK (VO < 0 or VO > VCC)

±50 mA

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Continuous output current, IO (VO = 0 to VCC)

±50 mA

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Continuous current through VCC or GND

±100 mA

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Maximum power dissipation at TA = 55°C (in still air) (see Note 2): D package

1.3 W

. . . . . . . . . . . . . . . . . . . .

N package

1.1 W

. . . . . . . . . . . . . . . . . . . .

PW package

0.5 W

. . . . . . . . . . . . . . . . . . .

Storage temperature range, Tstg

–65

°C to 150°C

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

† Stresses beyond those listed under “absolute maximum ratings” may cause permanent damage to the device. These are stress ratings only and

functional operation of the device at these or any other conditions beyond those indicated under “recommended operating conditions” is not

implied. Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability.

NOTES:

1. The input and output voltage ratings may be exceeded if the input and output current ratings are observed.

2. The maximum package power dissipation is calculated using a junction temperature of 150

_C and a board trace length of 750 mils,

except for the N package, which has a trace length of zero.

recommended operating conditions

MIN

MAX

UNIT

VCC

Supply voltage

4.5

5.5

VIH

High-level input voltage

VIL

Low-level input voltage

0.8

Input voltage

VCC

Output voltage

VCC

IOH

High-level output current

–24

IOL

Low-level output current

Dt/Dv

Input transition rise or fall rate

ns/ V

Operating free-air temperature

–40

°C

ACT11008 データシート(PDF) 2 Page - Texas Instruments

ACT11008 データシート(HTML) 2 Page - Texas Instruments

Html Pages

1 2 3 4 5

データシートダウンロード