ACT04 datasheet(2/15 Pages) TI

2 / 15 page

SN54ACT04, SN74ACT04

HEX INVERTERS

SCAS518C − JULY 1995 − REVISED OCTOBER 2003

POST OFFICE BOX 655303

• DALLAS, TEXAS 75265

logic diagram, each inverter (positive logic)

absolute maximum ratings over operating free-air temperature range (unless otherwise noted)†

Supply voltage range, VCC

−0.5 V to 7 V

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Input voltage range, VI (see Note 1)

−0.5 V to VCC + 0.5 V

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Output voltage range, VO (see Note 1)

−0.5 V to VCC + 0.5 V

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Input clamp current, IIK (VI < 0 or VI > VCC)

±20 mA

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Output clamp current, IOK (VO < 0 or VO > VCC)

±20 mA

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Continuous output current, IO (VO = 0 to VCC)

±50 mA

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Continuous current through VCC or GND

±200 mA

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Package thermal impedance,

θJA (see Note 2): D package

°C/W

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

DB package

°C/W

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

N package

°C/W

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

NS package

°C/W

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

PW package

113

°C/W

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Storage temperature range, Tstg

−65

°C to 150°C

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

† Stresses beyond those listed under “absolute maximum ratings” may cause permanent damage to the device. These are stress ratings only, and

functional operation of the device at these or any other conditions beyond those indicated under “recommended operating conditions” is not

implied. Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability.

NOTES:

1. The input and output voltage ratings may be exceeded if the input and output current ratings are observed.

2. The package thermal impedance is calculated in accordance with JESD 51-7.

recommended operating conditions (see Note 3)

SN54ACT04

SN74ACT04

UNIT

MIN

MAX

MIN

MAX

UNIT

VCC

Supply voltage

4.5

5.5

4.5

5.5

VIH

High-level input voltage

VIL

Low-level input voltage

0.8

Input voltage

VCC

Output voltage

VCC

IOH

High-level output current

−24

IOL

Low-level output current

∆t/∆v

Input transition rise or fall rate

ns/V

Operating free-air temperature

−55

125

−40

°C

NOTE 3: All unused inputs of the device must be held at VCC or GND to ensure proper device operation. Refer to the TI application report,

Implications of Slow or Floating CMOS Inputs, literature number SCBA004.

ACT04 データシート(PDF) 2 Page - Texas Instruments

ACT04 データシート(HTML) 2 Page - Texas Instruments

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

データシートダウンロード

リンク URL

ACT04 データシート(PDF) 2 Page - Texas Instruments

ACT04 データシート(HTML) 2 Page - Texas Instruments

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

データシート ダウンロード

リンク URL

データシートダウンロード