SPT9110 datasheet(4/11 Pages) CADEKA

4 / 11 page

11/12/98

SPT9110

TEST LEVEL CODES

All electrical characteristics are subject to the

following conditions: All parameters having min/

max specifications are guaranteed. The Test

Level column indicates the specific device test-

ing actually performed during production and

Quality Assurance inspection. Any blank sec-

tion in the data column indicates that the speci-

fication is not tested at the specified condition.

TEST LEVEL

III

TEST PROCEDURE

100% production tested at the specified temperature.

100% production tested at TA = +25 °C, and sample

tested at the specified temperatures.

QA sample tested only at the specified temperatures.

Parameter is guaranteed (but not tested) by design

and characterization data.

Parameter is a typical value for information purposes

only.

100% production tested at TA = +25 °C. Parameter is

guaranteed over specified temperature range.

ELECTRICAL SPECIFICATIONS

AVCC = +5.0 V, AGND = 0.0 V, RLoad = 1 kΩ and 10 pF, VIN = 2.0 Vp-p, Internal Reference, unless otherwise specified.

TEST

SPT9110

PARAMETERS

CONDITIONS

LEVEL

MIN

TYP

MAX

UNITS

Hold-to-Track Switching8

Acquisition Time to 0.1%

+25

°C

3.5

1 V Output Step

Acquisition Time to 0.025%

+25

°C

4.0

1 V Output Step

Power Supplies

Supply Voltage

4.75

5.25

Supply Current

Single Ended Output Mode9I

Differential Output Mode

Power Dissipation

Single Ended Output Mode9I

100

Differential Output Mode

120

150

Power Supply Rejection Ratio

+25

°C

Single-Ended Output

∆VCC = 0.5 VP-P

8. Measured at the hold capacitor.

9. Inverter powered down.

SPT9110 データシート(PDF) 4 Page - Cadeka Microcircuits LLC.

SPT9110 データシート(HTML) 4 Page - Cadeka Microcircuits LLC.

Html Pages

1 2 3 4 5 6 7 8 9 10 11

データシートダウンロード