CS2000-CP

DS761F1

17

continues while the PLL re-acquires lock (see Figure 15). When ClkSkipEn is disabled and CLK_IN is re-

moved the PLL output will continue until CLK_IN is re-applied at which point the PLL will go unlocked only

for the time it takes to acquire lock; the PLL_OUT state will be determined by the ClkOutUnl bit during this

time. When ClkSkipEn is enabled and CLK_IN is removed the PLL output clock will remain continuous

throughout the missing CLK_IN period including the time while the PLL re-acquires lock.

5.2.2

Adjusting the Minimum Loop Bandwidth for CLK_IN

The CS2000 allows the minimum loop bandwidth of the Digital PLL to be adjusted between 1 Hz and 128

Hz using the ClkIn_BW[2:0] bits. The minimum loop bandwidth of the Digital PLL directly affects the jitter

transfer function; specifically, jitter frequencies below the loop bandwidth corner are passed from the PLL

input directly to the PLL output without attenuation. In some applications it is desirable to have a very low

minimum loop bandwidth to reject very low jitter frequencies, commonly referred to as wander. In others

it may be preferable to remove only higher frequency jitter, allowing the input wander to pass through the

PLL without attenuation.

Referenced Control

Register Location

ClkSkipEn.............................. “Clock Skip Enable (ClkSkipEn)” on page 31

ClkOutUnl.............................. “Enable PLL Clock Output on Unlock (ClkOutUnl)” on page 32

CLK_IN

PLL_OUT

UNLOCK

ClkSkipEn=1

ClkOutUnl=0 or 1

CLK_IN

PLL_OUT

UNLOCK

ClkSkipEn=0

ClkOutUnl=1

Lock Time

CLK_IN

PLL_OUT

UNLOCK

ClkSkipEn=0

ClkOutUnl=0

Lock Time

= invalid clocks