2

5192C–SEEPR–01/09

AT24HC02B/04B

Figure 2-1.

Block Diagram

3.

Pin Description

SERIAL CLOCK (SCL): The SCL input is used to positive edge clock data into each EEPROM

device and negative edge clock data out of each device.

SERIAL DATA (SDA): The SDA pin is bi-directional for serial data transfer. This pin is open-

drain driven and may be wire-ORed with any number of other open-drain or open-collector

devices.

DEVICE/PAGE ADDRESSES (A2, A1, A0): The A2, A1 and A0 pins are device address inputs

that are hard wired for the AT24HC02B. As many as eight 2K devices may be addressed on a

single bus system (device addressing is discussed in detail under the Device Addressing

section).

Absolute Maximum Ratings

Operating Temperature

......................................−55°C to +125°C

*NOTICE:

Stresses beyond those listed under “Absolute

Maximum Ratings” may cause permanent dam-

age to the device. This is a stress rating only and

functional operation of the device at these or any

other conditions beyond those indicated in the

operational sections of this specification is not

implied. Exposure to absolute maximum rating

conditions for extended periods may affect device

reliability.

Storage Temperature

.........................................−65°C to +150°C

Voltage on Any Pin

with Respect to Ground

........................................ −1.0V to +7.0V

Maximum Operating Voltage .......................................... 6.25V

DC Output Current........................................................ 5.0 mA