HT82V42

Rev. 1.00

10

November 20, 2009

Offset Registers

There are three offset registers used to individually program the offset. Bits D7 through D0 control the offset range from

-315mV to 315mV in 256 increments.

The Table shows the offset range as a function of the bits D7 through D0.

D7

D6

D5

D4

D3

D2

D1

D0

Offset

(mV)

MSB

LSB

00000000

-315

:

:

:

:

1000000

0*

0

:

:

:

:

11111111

+315

Note :*Power-on default value

Offset Register Settings

ADC Input Black Level Adjust

The output from the PGA should be offset to match the

full-scale range of the ADC (VFS=2.0V). For nega-

tive-going input video signals, a black level (zero differ-

ential) output from the PGA should be offset to the top of

the ADC range by setting register bits PGAFS[1:0]=10.

For positive going input signal the black level should be

offset to the bottom of the ADC range by setting

PGAFS[1:0]=11. Bipolar input video is accommodated

by setting PGAFS[1:0]=00 or PGAFS[1:0]=01 (zero dif-

ferential input voltage gives mid-range ADC output).

Overall Signal Flow Summary

The input sampling block produces an effective input

voltage V1. For CDS, this is the difference between the

input video level VIN and the input reset level VRESET.

For non-CDS this is the difference between the input

video level VIN and the voltage on the VRLC/VBIAS pin,

VVRLC, optionally set via the RLC DAC.

The offset DAC block then adds the amount of fine offset

adjustment required to move the black level of the input

signal towards 0V, producing V2.

The PGA block then amplifies the white level of the input

signal to maximise the ADC range, outputting voltage

V3.

The ADC block then converts the analogue signal, V3,

to a 16-bit unsigned digital output, D1. The digital output

is then inverted, if required, through the output invert

block to produce D2.

Calculating Output for any Given Input

The following equations describe the processing of the

video and reset level signals through the HT82V42. The

values of V1, V2 and V3 are often calculated in reverse

order during device setup. The PGA value is written first

to set the input Voltage range, the Offset DAC is then

adjusted to compensate for any Black/Reset level off-

sets and finally the RLC DAC value is set to position the

reset level correctly during operation.

Overall Signal Flow