PACUSB-D1/D2/D3

Rev. 2 | Page 7 of 10 | www.onsemi.com

Application Information

The PACUSB-D1/D2/D3 provides a complete interface for a single downstream USB port typically found in

computers and USB hubs. It integrates the series resistors (R1) and the 15k

Ω pull-down resistors (R2) for both

USB data lines (D+ and D-) as well as the capacitors to ground for EMI suppression. Zener diodes provide ESD

protection up to 15kV contact discharge per the IEC 61000-4-2 standard and protect the USB controller on both

data lines.

The PACUSB-D1/D2/D3 should be placed on the PCB between the USB controller and the USB connector, as

shown on the Connection Diagram, Figure 5.

Figure 5. Connection Diagram for PACUSB-D1/D2/D3 Devices

To guarantee the best ESD and filtering performance, it is recommended to physically locate the PACUSB-

D1/D2/D3 close to the USB connector. Also, the trace lengths between the PACUSB-D1/D2/D3 and the USB

controller should be kept as short as possible.