REF3125AIDBZ datasheet(13/48 Pages) TI1

部品番号	REF3125AIDBZ

部品情報	Contains all support circuitry needed for the ADS1174/ADS1274

PDF	48 Pages

Scroll/Zoom	100%

メーカー	TI1 [Texas Instruments]

ホームページ	http://www.ti.com

Logo

13 / 48 page

9.2

Setting Up the ADS1274EVM-PDK

www.ti.com

ADS1274EVM-PDK Kit Operation

The ADS1274EVM-PDK contains both the ADS1274EVM and the MMB0 motherboard; however, the

devices are shipped unconnected. Follow these steps to set up the ADS1274EVM-PDK.

Step 1.

Unpack the ADS1274EVM-PDK kit.

Step 2.

Set the jumpers and switches on the MMB0 as shown in Figure 9.

•

Set the Boot Mode switch to USB.

•

Connect +5V and +5VA on jumper block J13 (if +5V is supplied from J14 +5VA).

•

Leave +5V and +VA disconnected on jumper block J13.

•

If the PDK will be powered from an AC adapter, connect J12. If the PDK will be powered

through the terminal block, disconnect J12. (See Section 9.3 for details on connecting the

power supply.)

Figure 9. MMB0 Initial Setup

SBAU134A – August 2008 – Revised May 2009

ADS1174EVM, ADS1274EVM, ADS1174EVM-PDK, and ADS1274EVM-PDK

Submit Documentation Feedback

REF3125AIDBZ データシート(PDF) 13 Page - Texas Instruments