ST72101 datasheet(9/85 Pages) STMICROELECTRONICS

部品番号	ST72101

部品情報	8-BIT MCU WITH 4 TO 8K ROM/OTP/EPROM, 256 BYTES RAM, ADC, WDG, SPI AND 1 OR 2 TIMERS

PDF	85 Pages

Scroll/Zoom	100%

メーカー	STMICROELECTRONICS [STMicroelectronics]

ホームページ	http://www.st.com

Logo

9 / 85 page

Obsolete

Product(s)

- Obsolete

Product(s)

9/85

ST72101/ST72212/ST72213

1.3 EXTERNAL CONNECTIONS

The following figure shows the recommended ex-

ternal connections for the device.

The VPP pin is only used for programming OTP

and EPROM devices and must be tied to ground in

user mode.

The 10 nF and 0.1 µF decoupling capacitors on

the power supply lines are a suggested EMC per-

formance/cost tradeoff.

The external reset network is intended to protect

the device against parasitic resets, especially in

noisy environments.

Unused I/Os should be tied high to avoid any un-

necessary power consumption on floating lines.

An alternative solution is to program the unused

ports as inputs with pull-up.

Figure 8. Recommended External Connections

VPP

VDD

VSS

OSCIN

OSCOUT

RESET

VDD

0.1µF

See

Clocks

Section

VDD

0.1µF

EXTERNAL RESET CIRCUIT

Or configure unused I/O ports

Unused I/O

10nF

4.7K

10K

by software as input with pull-up

VDD

ST72101 データシート(PDF) 9 Page - STMicroelectronics

ST72101 データシート(HTML) 9 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85

データシートダウンロード