M41T83RM6F datasheet(18/61 Pages) STMICROELECTRONICS

18 / 61 page

Operation

M41T82-M41T83

18/61

Doc ID 12578 Rev 12

2.4

Data retention and battery switchover (VSO = VRST)

Once VCC falls below the switchover voltage (VSO = VRST), the device automatically

switches over to the battery and powers down into an ultra low current mode of operation to

preserve battery life. If VBAT is less than, or greater than VRST, the device power is switched

from VCC to VBAT when VCC drops below VRST (see Figure 26 on page 50). At this time the

clock registers and user RAM will be maintained by the attached battery supply.

When it is powered back up, the device switches back from battery to VCC at VSO +

hysteresis. When VCC rises above VRST, it will recognize the inputs. For more information

on battery storage life refer to Application Note AN1012.

2.5

Power-on reset (trec)

The M41T8x continuously monitors VCC. When VCC falls to the power fail detect trip point,

the RST output pulls low (open drain) and remains low after power-up for trec (210 ms

typical) after VCC rises above VRST (max).

Note:

The trec period does not affect the RTC operation. Write protect only occurs when VCC is

below VRST. When VCC rises above VRST, the RTC will be selectable immediately. Only the

RST output is affected by the trec period.

The RST pin is an open drain output and an appropriate pull-up resistor to VCC should be

chosen to control the rise time.

M41T83RM6F データシート(PDF) 18 Page - STMicroelectronics