Angled corner

indicates pin one.

0.000

0.120 (3.05)

0.250 (6.35)

0.450 (11.43)

0.650 (16.51)

0.850 (21.59)

1.050 (26.67)

1.250 (31.75)

1.380 (35.05)

0.128 dia

(3.25).

0.040 dia

(1.02)

Seam Seal

TOP VIEW CASE U2

Flanged case, short leads

0.300 ±0.050 (7.60 ±1.27) Pin length

1

2

3

4

5

6

12

11

10

9

8

7

1.505 max. (38.23)

Case U2 does not require designator in Case Option position of model number for the MOR family

Case dimensions in inches (mm)

Tolerance ±0.005 (0.13) for three decimal places

±0.01 (0.3) for two decimal places

unless otherwise specified

CAUTION

Heat from reflow or wave soldering may damage the device. Solder pins

individually with heat application not exceeding 300°C for 10 seconds per pin.

Materials

Header

Cold Rolled Steel/Nickel/Gold

Cover

Kovar/Nickel

Pins

#52 alloy/Gold, compresion glass seal

Seal Hole: 0.100 ±0.002 (2.54 ±0.05)

Case U2, Rev E, 20100401

Please refer to the numerical dimensions for accuracy. All information is believed to

be accurate, but no responsibility is assumed for errors or omissions. Interpoint

reserves the right to make changes in products or specifications without notice.

Copyright © 1999-2010 Interpoint Corp. All rights reserved.

Crane Aerospace & Electronics Power Solutions

Mor single and dual dc/dc converter cases

28 Volt input – 120 Watt

www.interpoint.com

Page 18 of 24

MOR Rev K - 20100422