LifecyclePhase:

Revision

: 2

Expired Period: Forever

Release Date:2008-09-20 00:15:58.0

EVERLIGHT ELECTRONICS CO.,LTD.

Everlight Electronics Co., Ltd.

http://www.everlight.com

Rev. 2

Page: 12 of 12

Device No. : DSE-937-C01

Prepared date: 15-Aug-2008

Prepared by : Ashley Kuo

19-237B/R6GHBHC-C01/2T

4.Soldering Iron

Each terminal is to go to the tip of soldering iron temperature less than 350℃ for 3 seconds within

once in less than the soldering iron capacity 25W. Leave two seconds and more intervals, and do

soldering of each terminal. Be careful because the damage of the product is often started at the time of the

hand solder.

5.Repairing

Repair should not be done after the LEDs have been soldered. When repairing is unavoidable, a

double-head soldering iron should be used (as below figure). It should be confirmed beforehand whether

the characteristics of the LEDs will or will not be damaged by repairing.

EVERLIGHT ELECTRONICS CO., LTD.

Tel: 886-2-2267-2000, 2267-9936

Office: No 25, Lane 76, Sec 3, Chung Yang Rd,

Fax: 886-2267-6244, 2267-6189, 2267-6306

Tucheng, Taipei 236, Taiwan, R.O.C

http://www.everlight.com