LIS352AX datasheet(10/15 Pages) STMICROELECTRONICS

部品番号	LIS352AX

部品情報	MEMS inertial sensor: 3-axis ±2 g absolute analog-output "piccolo" accelerometer

PDF	15 Pages

Scroll/Zoom	100%

メーカー	STMICROELECTRONICS [STMicroelectronics]

ホームページ	http://www.st.com

Logo

10 / 15 page

Application hints

LIS352AX

10/15

Doc ID 15530 Rev 2

Application hints

Figure 3.

LIS352AX electrical connection

Power supply decoupling capacitors (100 nF ceramic or polyester + 10 µF aluminum) should

be placed as near as possible to the device (common design practice).

The LIS352AX allows band limiting of Voutx, Vouty and Voutz through the use of external

capacitors. The recommended frequency range spans from DC up to 2.0 kHz. Capacitors

must be added at the output pins to implement low-pass filtering for anti-aliasing and noise

reduction, even if only the multiplexed output (Vout) is used. The equation for the cut-off

frequency ( ft ) of the external filters is:

Taking into account that the internal filtering resistor (Rout) has a nominal value of 32 kΩ, the

equation for the external filter cut-off frequency may be simplified as follows:

π R

out

load xyz

()

⋅⋅

------------------------------------------------------------------------

µF

load xyz

()

--------------------------------------- Hz

[]

LIS352AX データシート(PDF) 10 Page - STMicroelectronics