Si4010-DK

Rev. 0.1

3

1.1.1. Burning Adapter (P/N MSC-BA4)

The programming interface board serves as an interface in between the debug adapter and the Socketed Key Fob

Development Board or the Development Key Fob. It provides 6.5 V for NVM programming. The power source is

activated by a sliding switch on the board. It is required when the user wants to program the internal NVM memory

on the chip.

The programming interface board contains an 8-pin header, to which GPIO0 to GPIO5, along with power and

ground, are connected from the development boards. Therefore, the user can tap to that header to control or

monitor the chip pins.

1.1.2. Si4010 Socketed Key Fob Development Board (P/N MSC-DKPE1)

Socketed (both SOIC and MSOP) key fob board with SMA connector.