Application information

TS556

12/19

4

Application information

4.1

Monostable operation

In the monostable mode, the timer operates like a one-shot generator. Referring to figure 2,

the external capacitor is initially held discharged by a transistor inside the timer, as shown in

Figure 4.

Figure 4.

Application schematic

triggered, the circuit remains in this state until the set time has elapsed, even if it is triggered

again during this interval. The duration of the output HIGH state is given by t = 1.1 R x C.

It can be noticed that since the charge rate and the threshold level of the comparator are

both directly proportional to the supply voltage, the timing interval is independent of the

supply. Applying a negative pulse simultaneously to the Reset terminal (pin 4) and the

Trigger terminal (pin 2) during the timing cycle discharges the external capacitor and causes

the cycle to start over. The timing cycle now starts on the positive edge of the reset pulse.

While the reset pulse is applied, the output is driven to the LOW state.

When a negative trigger pulse is applied to pin 2, the flip-flop is set, releasing the short

circuit across the external capacitor and driving the output HIGH. The voltage across the

capacitor increases exponentially with the time constant

τ = R x C.

which then discharges the capacitor rapidly and drives the output to its LOW state.

Figure 5 shows the actual waveforms generated in this mode of operation.

When Reset is not used, it should be tied high to avoid any possible or false triggering.

Figure 5.

Timing diagram

Reset

Trigger

Out

R

C

Control Voltage

0.01 F

μ

1/2

TS556

CAPACITOR VOLTAGE = 2.0V/div

Ω

Ω

μ

t = 0.1 ms / div

INPUT = 2.0V/div

OUTPUT VOLTAGE = 5.0V/div

R = 9.1k , C = 0.01 F , R = 1.0k

L