 |
データシートサーチシステム |
|
|
データシートサーチシステム |
|
ACT4418D データシート(PDF) 1 Page - Aeroflex Circuit Technology |
|
|
|||||||||||||||||||||||||||||
ACT4418D データシート(HTML) 1 Page - Aeroflex Circuit Technology |
|
|
1 / 7 page  CIRCUIT TECHNOLOGY www.aeroflex.com/act1.htm eroflex Circuit T echnology – Data Bus Modules For The Future © SCD4418D REV A 9/24/97 Features • ACT4418 Dual Transceivers meets MIL-STD-1553A&B, Macair A3818, A4905, A5232 and A5690 Specs • ±12 Volt Power Supply Operation • Voltage source output for higher bus drive power • Molded Plug-in package • Monolithic construction using linear ASICs • Variable TX Amplitude • Processed and Screened to Mil-STD-883 Specs for Industrial temperature range General Description The Aeroflex Circuit Technology ACT4418D is a new generation monolithic transceivers which provide full compliance with Macair and MIL- STD-1553 data bus requirements while providing variable amplitude control. The ACT4418D performs the front- end analog function of inputting and outputting data through a transformer to a MIL-STD-1553 or Macair data bus. The ACT4418D can be consid- ered a "Universal" Transceiver in that it is compatible with MIL-STD-1553A, B, Macair A-3818, A-4905, A-5232 and A-5690. Design of these transceivers reflects particular attention to active filter performance.This results in low bit and word error rate with superior waveform purity and minimal zero crossover distortion. The ACT4418D active filter design has additional high frequency roll-off to provide the required Macair low harmonic distortion waveform without increasing the pulse delay characteristics significantly. Efficient transmitter electrical and thermal design provides low internal power dissipation and heat rise at high and well as low duty cycles. Variable amplitude is adjusted with 0–10 Vdc on the control pin. Transmitter: The Transmitter section accepts bi- phase TTL data at the input and when coupled to the data bus with a 1:1 transformer, isolated on the data bus side with two 52.5 Ohm fault iso- lation resistors, and loaded by two 70 Block Diagram (without Transformer) SHAPING OUTPUT STAGE COMP. COMP. ACTIVE FILTER INPUT AMP DRIVER TX DATA IN TX DATA IN TX INHIBIT +5V RX DATA IN RX DATA IN STROBE TX DATA OUT TX DATA OUT RX DATA OUT RX DATA OUT -12V +12V V+ V- AMP CONTROL One Channel GROUND ACT4418 Molded Dual Variable Amplitude Transceivers & MIL-STD-1553 for MACAIR A3818, A5690, A5232, A4905 |
同様の部品番号 - ACT4418D |
|
同様の説明 - ACT4418D |
|
|
|
リンク URL |
| ALLDATASHEETはお客様のビジネスに役立ちますか？ [ DONATE ] |
Alldatasheetは | 広告 | お問い合わせ | プライバシーポリシー | データシートへのリンク | リンク交換 | メーカーリスト All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |
Japanese ▼
English
Chinese
German
Japanese
Russian
Korean
Spanish
French
Italian
Portuguese
Polish
Vietnamese
Indian
Mexican
British
New Zealand
