Crimped MIL Connector Sockets for Discrete Wires

XG5N/XG5N-U

3

AssemblyTools

Manual Crimping Tool

XY2B-7007

Contact Removal Tool

XY2E-0003

Automatic Applicator

Use an Applicator that is manufactured by Japan Automatic Machine

Co., Ltd. Contact information is provided below.

Japan:

Japan Automatic Machine Co., Ltd.

TEL 03-3756-1434

China:

Japan Automatic Machine Technology (Huizhou) Ltd.

6-1-B,Songshan Industrial Park, Huizhou Zhongkai Hi-Tech

Industrial Development Zone, Huizhou,Guangdong,China

TEL(86-752)2771-614 FAX(86-752)2771-619

South-eastern Asia:

Japan Automatic Machine Singapore Pte. Ltd.

HB Centre 12 Tannery Road #04-02, Singapore 347722

TEL 65-6545-8140 FAX 65-6545-8141

USA, Europe:

Toyojamco, Ltd.

8370 Burnahm Road Suite 200 EL Paso, TX 79907 USA

TEL (915)595-8825 FAX (915)595-8794

*1: Inquire for details.

*2: This model number is for standard specifications.

Inquire for other specifications.

Safety Precautions

Crimping Method

Always use the specified Crimping Tool or Applicator to wire the

crimped contacts.

Refer to the instruction sheet that is provided separately for details.

Contact Insertion Method

Confirm the orientation of the crimped contacts and then insert them

all the way to the back of the Socket. After insertion, confirm that the

lances are securely set in the lance holes on the socket housing.

Contact Replacement Method

To remove contacts that have been incorrectly inserted, always use

the XY2E-0003 Contact Removal Tool.

1. Insert the end of the Removal

Tool into the lance hole in the

socket housing and press the

lance all the way inside the

socket housing.

2. While pressing in on the lance,

pull out the Contact.

3. Insert a new Contact.

Note: Do not use any Contacts that have

been removed.

Attaching the Lock Levers

Attach the holes in the Lock Levers to the protrusions on both sides

of the housing and make sure that they are set securely.

Precautions for Correct Use

When mating the Sockets with XG4C Box Plugs, always use the

XG5U-0001 Lock Levers. Otherwise the Connectors may become

disconnected due to vibration or shock.

Storage

1. Do not store the Sockets in locations subject to dust or high

humidity.

2. Do not store the Sockets in locations close to sources of gasses

such ammonia gas or sulfide gas.

Model

Minimum ordering quantity

(pieces)

XY2B-7007

1

Model

Minimum ordering quantity

(pieces)

XY2E-0003

1

Crimping Machine

Strip Crimper

Crimp Contacts, Type 1

Planned for the near

Crimp Contacts, Type 2

Before Insertion

After Insertion (Set in Socket)

Lance hole

Lance