AD7680BRJZ-R2 datasheet(14/24 Pages) AD

14 / 24 page

AD7680

Rev. A | Page 14 of 24

MODES OF OPERATION

The mode of operation of the AD7680 is selected by controlling

the (logic) state of the CS signal during a conversion. There are

two possible modes of operation, normal and power-down. The

point at which CS is pulled high after the conversion has been

initiated determines whether or not the AD7680 enters power-

down mode. Similarly, if the AD7680 is already in power-down,

CS can control whether the device returns to normal operation

or remains in power-down. These modes of operation are

designed to provide flexible power management options. These

options can optimize the power dissipation/throughput rate

ratio for differing application requirements.

NORMAL MODE

This mode provides the fastest throughput rate performance,

because the user does not have to worry about the power-up

times with the AD7680 remaining fully powered all the time.

Figure 16 shows the general diagram of the operation of the

AD7680 in this mode.

The conversion is initiated on the falling edge of CS as described

in the

section. To ensure that the part remains

fully powered up at all times,

Serial Interface

CS must remain low until at least

10 SCLK falling edges have elapsed after the falling edge of CS.

If CS is brought high any time after the 10th SCLK falling edge,

but before the 20th SCLK falling edge, the part remains

powered up, but the conversion is terminated and SDATA goes

back into three-state. At least 20 serial clock cycles are required

to complete the conversion and access the complete conversion

result. In addition, a total of 24 SCLK cycles accesses four

trailing zeros. CS may idle high until the next conversion or

may idle low until CS returns high sometime prior to the next

conversion, effectively idling CS low.

Once a data transfer is complete (SDATA has returned to three-

state), another conversion can be initiated after the quiet time,

tQUIET, has elapsed by bringing CS low again.

110

4 LEADING ZEROS + CONVERSION RESULT

SCLK

SDATA

Figure 16. Normal Mode Operation

AD7680BRJZ-R2 データシート(PDF) 14 Page - Analog Devices

AD7680BRJZ-R2 データシート(HTML) 14 Page - Analog Devices

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24

データシートダウンロード