SC212KSIT datasheet(12/13 Pages) SECELECTRONICS

12 / 13 page

SC212KSIT

120 kHz Bandwidth, High Voltage Isolation

Current Sensor with Integrated Overcurrent Detection

12/13

starts discharging.

When the FAULT pin voltage reaches approximately 2 V, the fault is latched, and an internal

NMOS device pulls the FAULT pin voltage to approximately 0 V. The rate at which the

FAULT pin slews downward (see [4] in the figure) is dependent on the external capacitor, COC,

on the FAULT pin.

When the FAULT_EN pin is brought low, the FAULT pin starts resetting if no OC fault

condition exists, and if FAULT_EN is low for a time period greater than tOCH. The internal

NMOS pull-down turns off and an internal PMOS pullup turns on (see [7] if the OC fault

condition still exists).

The slope, and thus the delay to latch the fault is controlled by the capacitor, COC, placed on the

FAULT pin to ground. During this portion of the fault (when the FAULT pin is between VCC and

2 V), there is a 3 mA constant current sink, which discharges COC. The length of the fault delay, t

is equal to:

)

(

−

where VCC is the device power supply voltage in volts, t is in seconds and COC is in Farads. This

formula is valid for RPU

equal to or greater than 330 kΩ. For lower-value resistors, the current

flowing through the RPU resistor during a fault event, IPU , will be larger. Therefore, the current

discharging the capacitor would be 3 mA – IPU and equation 1 may not be valid.

The FAULT pin did not reach the 2 V latch point before the OC fault condition cleared. Because

of this, the fixed 3 mA current sink turns off, and the internal PMOS pull-up turns on to recharge

COC through the FAULT pin.

This curve shows VCC charging external capacitor COC through the internal PMOS pull-up. The

slope is determined by COC.

When the FAULT_EN pin is brought low, if the fault condition still exists, the latched

FAULT pin will be pulled low by the internal 3mA current source. When fault condition is

removed then the Fault pin charges as shown in step 6.

At this point there is a fault condition, and the part is enabled before the FAULT pin can charge to

VCC. This shortens the user-set delay, so the fault is latched earlier. The new delay time can be

calculated by equation 1, after substituting the voltage seen on the FAULT pin for VCC.

Vcc

Fault_En

Input

OC Fault Condition

(Active High)

SC212KSIT データシート(PDF) 12 Page - SEC Electronics Inc.

SC212KSIT データシート(HTML) 12 Page - SEC Electronics Inc.

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13

データシートダウンロード