UG-521

Evaluation Board User Guide

Rev. 0 | Page 4 of 8

EVALUATION BOARD SOFTWARE QUICK START PROCEDURES

The control software for EVAL-CN0285-EB1Z uses the

standard ADF4351 programming software. For more details on

the installation of this software, consult UG-435, Evaluation

Board for the ADF4351 Fractional-N PLL Frequency Synthesizer.

After installing the software, run the software by clicking the

ADI ADF435x file on the desktop or in the Start menu. The

software front panel opens (see Figure 3).

Confirm that Analog Devices RFG.L Eval Board connected is

displayed in the bottom left corner of the window. Otherwise,

the software has no connection to the evaluation board. In this

case, check that the cable connection and USB drivers are

correctly installed.

Program the RF output frequency in the Main Controls tab of

the software front panel.

Figure 3. Software Front Panel