USB2533 datasheet(15/61 Pages) SMSC

15 / 61 page

USB 2.0 Hi-Speed 3-Port Hub Controller

Datasheet

SMSC USB2533

Revision 1.0 (06-17-13)

DATASHEET

External USB

Transceiver

Bias Resistor

RBIAS

A 12.0k

Ω (+/- 1%) resistor is attached from

ground to this pin to set the transceiver’s internal

bias settings.

LED 0 Output

LED0

General purpose LED 0 output that is

configurable to blink or “breathe” at various rates.

Note:

LED0 must be enabled via the Protouch

configuration tool.

Detect

Upstream

VBUS Power

VBUS_DET

Detects state of upstream bus power.

When designing a detachable hub, this pin must

be connected to the VBUS power pin of the

upstream USB port through a resistor divider

(50k

Ω by 100kΩ) to provide 3.3V.

For self-powered applications with a permanently

attached host, this pin must be connected to

either 3.3V or 5.0V through a resistor divider to

provide 3.3V.

In embedded applications, VBUS_DET may be

controlled (toggled) when the host desires to

renegotiate a connection without requiring a full

reset of the device.

Table 3.1 Pin Descriptions (continued)

NUM PINS

NAME

SYMBOL

BUFFER

TYPE

DESCRIPTION

USB2533 データシート(PDF) 15 Page - SMSC Corporation

USB2533 データシート(HTML) 15 Page - SMSC Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61

データシートダウンロード