MPC507AP datasheet(16/19 Pages) TI

16 / 19 page

MECHANICAL DATA

MPDI056 – APRIL 2001

POST OFFICE BOX 655303

• DALLAS, TEXAS 75265

NTD (R-PDIP-T28)

PLASTIC DUAL-IN-LINE

4202496/A 03/01

1.565 (39,75)

1.380 (35,05)

0.485 (12,32)

0.580 (14,73)

Area

0.625 (15,88)

0.600 (15,24)

0.015 (0,38)

0.008 (0,20)

0.200 (5,08)

0.115 (2,92)

0.195 (4,95)

0.125 (3,18)

0.070 (1,78)

0.030 (0,76)

Index

0.100 (2,54)

–C–

0.250 (6,35)

MAX

0.600 (15,26)

0.060 (1,52)

0.000 (0,00)

0.700 (17,78)

MAX

0.015 (0,38)

MIN

0.005 (0,13)

MIN 4 PL

Full Lead

0.014 (0,36)

0.022 (0,56)

Seating

Plane

Base

Plane

0.010 (0,25)

NOTES: A. All linear dimensions are in inches (millimeters).

B. This drawing is subject to change without notice.

C. Dimensions are measured with the package

seated in JEDEC seating plane gauge GS-3.

D. Dimensions do not include mold flash or protrusions.

Mold flash or protrusions shall not exceed 0.010 (0,25).

E. Dimensions measured with the leads constrained to be

perpendicular to Datum C.

F. Dimensions are measured at the lead tips with the

leads unconstrained.

G. Pointed or rounded lead tips are preferred to ease

insertion.

H. Maximum dimension does not include dambar

protrusions. Dambar protrusions shall not exceed

0.010 (0,25).

I. Distance between leads including dambar protrusions

to be 0.005 (0,13) minumum.

J. A visual index feature must be located within the

cross-hatched area.

K. For automatic insertion, any raised irregularity on the

top surface (step, mesa, etc.) shall be symmetrical

about the lateral and longitudinal package centerlines.

L. Controlling dimension in inches.

M. Falls within JEDEC MS-011-AB.

MPC507AP データシート(PDF) 16 Page - Texas Instruments

MPC507AP データシート(HTML) 16 Page - Texas Instruments

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19

データシートダウンロード