A22E

Control Box (Enclosure)

Installing/Removing the Switch Blocks

(1) Mounting the Switch

(2) Creating a Cable Port Hole

The Standard-size Legend Plate Frame can be mounted. Mount the Frame as

shown in the following diagram. Mount the Switch in the same way as for an

ordinary panel.

Place the tip of a screwdriver on the surface where the cable port hole is to be

created with the cover attached and strike the screwdriver to punch a hole.

Attempts to punch a hole on the other side of the case will damage the Box.

(3) Securing the Connector Cable

1. Insert the connector into the cable port hole in the Box and secure with the fixing nut inside the box.

2. Open a hole in the thin rubber section of the rubber ring.

3. Pass the tightening cap through the cable, insert the cable into the connector, and tighten the hexagonal nut to secure the cable.

(1) Installing the Switch Blocks

(2) Removing the Switch Blocks

Wiring

• Hook the small protrusion on the Mounting Latch

into the groove on the other side of the lever, then

push up the Switch Block in the direction indicated

by the arrow in the figure below.

• Insert a screwdriver between the Mounting Latch

and the Switch Block, then push down the

screwdriver in the direction indicated by the arrow

in the following figure.

• Loosen the terminal screw from the Switch

Unit until it completely comes off the groove,

insert a screwdriver as shown in the following

figure, then push up the washer in the

direction indicated by the arrow to temporarily

secure it. Now, a round crimp terminal can be

connected. After inserting the terminal,

tighten the screws to complete wiring.

Snap-in Legend Plate

Lock nut

Rubber washer

Connector

Outside

Inside

Box

Cable

Tightening

Cable diameter

Connector

7 to 9 dia.

A22Z-3500-1

9 to 11 dia.

A22Z-3500-2

Switch block

Protrusion

Lever

Mounting

Latch

Use either of the following screwdrivers.

Flat-head screwdriver

3 to 6 mm

3 to 6 mm dia.

Phillips screwdriver

Screwdriver

Screwdriver

Washer

Screw

http://www.ia.omron.com/

18

(c)Copyright OMRON Corporation 2007 All Rights Reserved.