UR5596-SH2-R datasheet(8/12 Pages) ETL

8 / 12 page

UR5596

CMOS IC

UNISONICTECHNOLOGIESCO.,LTD

8 of 12

www.unisonic.com.tw

QW-R502-045,C

TYPICAL APPLICATION CIRCUITS(Cont.)

Figure 3 illustrate another application that the power rails are split when power dissipation or efficiency are

concerned. The output stage (PVIN) can be as lower as 1.8V, and the analog circuitry (AVIN) can be connected to a

higher rail such as 2.5V, 3.3V or 5V. This allows the internal power dissipation to be lowered when sourcing current

from VTT, but the disadvantage of this circuit is the maximum continuous current is reduced.

VTT

VDDQ

VSENSE

VREF

GND

SHDN

AVIN

PVIN

CIN

SHDN

VDDQ=2.5V

AVIN=2.2V ~ 5.5V

COUT

CREF

VREF=1.25V

VTT=1.25V

UTC UR5596

PVIN=1.8V

Figure 3. Lower Power Dissipation SSTL-2 Implementation

The third optional application is that PVIN connect to 3.3V and AVIN will be always limited to operation on the 3.3V

or 5V to always equal or higher than PVIN. This configuration has the ability to provide the maximum continuous

output current at the downside of higher thermal dissipation. The power dissipation increasing problem must be

careful to prevent the junction temperature to exceed the maximum ranting. Because of this risk it is not

recommended to supply the output stage with a voltage higher than a nominal 3.3V rail.

VTT

VDDQ

VSENSE

VREF

GND

SHDN

AVIN

PVIN

CIN

SHDN

VDDQ=2.5V

AVIN=3.3V or 5.5V

COUT

CREF

VREF=1.25V

VTT=1.25V

UTC UR5596

PVIN=3.3V

Figure 4. SSTL-2 Implementation with higher voltage rails

UR5596-SH2-R データシート(PDF) 8 Page - E-Tech Electronics LTD

UR5596-SH2-R データシート(HTML) 8 Page - E-Tech Electronics LTD

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12

データシートダウンロード

リンク URL

UR5596-SH2-R データシート(PDF) 8 Page - E-Tech Electronics LTD

UR5596-SH2-R データシート(HTML) 8 Page - E-Tech Electronics LTD

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12

データシート ダウンロード

リンク URL

データシートダウンロード