AN2281 datasheet(21/38 Pages) STMICROELECTRONICS

21 / 38 page

AN2281

Getting started with the ST7FLITE35-based PMAC motor control system

21/38

Figure 15. Softec STVD7 ver3.10 development tool

6.2.2

Real time emulators

Two types of real-time development tools are available for debugging applications using

ST7FLITE35:

●

In-circuit debugger from Softec (sales type: STXF-INDART/USB).The inDART-STX

from Softec Microsystems is both an emulator and a programming tool. This is

achieved using the In-circuit debug module embedded on the MCU. The real-time

features of the Indart include access to working registers and 2 breakpoint settings.

However trace is not available.

●

ST7MDT10-EMU3. Full-featured emulator: real-time with trace capability, performance

analysis, advanced breakpoints, some logic analyzer capabilities,... You can also use it

as a programming tool with the ICC ADDON module, which is included with the

emulator. This ICC-ADDON module allows you to do In-Circuit-Debugging with STVD7.

6.2.3

Programmers

In order to program an MCU with the generated S19 file, output of the compilation, you

should also install the ST Visual Programmer software (available on ST website

www.st.com) and use a dedicated hardware programming interface (STICK programmer for

In-Circuit-Programming, for instance). The Visual Programming tool provides an easy way to

erase, program and verify the MCU contents.

Please note that the inDART-STX from Softec Microsystems is also a programming tool

(installation of DataBlaze Programmer software is required).

AN2281 データシート(PDF) 21 Page - STMicroelectronics