2) Use LEDs with stand-off (Fig.5) or the tube or spacer made of resin (Fig.6) to position the LEDs.

yFORMED LEAD

1) The lead should be bent at a point located at least 2mm away from the package. Bending

should be performed with base fixed means of a jig or pliers (Fig.7)

2) Forming lead should be carried our prior to soldering and never during or after soldering.

3) Form the lead to ensure alignment between the leads and the hole on board, so that stress

against the LED is prevented. (Fig.8)

Page : 7

Stand-off

Fig.5

Fig.6

Tube

)LJ

LED

LAMP APPLICATION