M08045 datasheet(32/49 Pages) MA-COM

32 / 49 page

Functional Description

M08035, M08045 Data Sheet V1

MACOM

™

080x5-DSH-001

4.7

Reclocker Operation

4.7.1

Clock Recovery

This block generates a serial clock signal at a frequency close to the data rate. The clock signal is generated by a

phased locked loop (PLL) which uses the 27 MHz input clock as a reference.

The presence of the reference clock is monitored by the device. An alarm bit (NOREF) in register 88h is set to '1'

when a suitable reference clock is not present. Once the PLL has locked to the reference clock, the REFLOL bit in

the same register will be set to '0'. A value of '1' in this bit indicates that the PLL has not locked to the input

reference clock.

The frequency locked clock signal is supplied to the phase lock block. In this block, a bang-bang phase comparator

is used to make fine adjustments to the phase and frequency of the clock, aligning it with the incoming serial data.

Once the clock signal is phase and frequency aligned with the serial data stream, it is used to re-time the data,

producing a clean data signal that is provided at the output of the device. The phase lock block uses an integrated,

programmable loop filter. The bandwidth of the phase lock block may be programmed using the BW[2:0] bits in

bandwidth also allows more jitter from the input serial data stream to be transferred to the output. Alternatively, a

low bandwidth setting causes the loop to reject more of the incoming data stream's jitter, while increasing lock time,

and reducing input jitter tolerance. The bandwidth setting can be optimized for each system.

Furthermore, since the phase lock block uses a non-linear, bang-bang loop, the bandwidth of the system is

inversely proportional to the incoming data stream's jitter. This offers several advantages over linear PLLs. It

achieves higher jitter attenuation with large input jitter, while it corrects for small variations quickly with low input

jitter. With higher input jitter, the loop automatically reduces the bandwidth, causing more of the jitter to be rejected.

Conversely, a data stream with lower jitter will cause the loop bandwidth to be widened. Note that bandwidth

settings greater than 2x will increase output jitter.

When the recovered serial clock output is enabled, the clock alignment to the SDOA data output will be typically

60 ps, where the falling edge of the clock lags the transition edge of the SDOA signal.

4.7.2

Automatic Rate Detection

The reclocker features an Automatic Rate Detector (ARD) circuit that monitors the input signal rate and

automatically sets the reclocker to the correct video rate. The data rate determined by the ARD block may be read

from bits 1:0 in register 89h as shown in Table 4-9.

Table 4-9.

Reclocker Rate Detection

Reg89h (Bits 1:0)

Function

00b

Reclocker unlocked

01b

SD rate detected

10b

HD rate detected

11b

3G rate detected (M08045)

M08045 データシート(PDF) 32 Page - M/A-COM Technology Solutions, Inc.

M08045 データシート(HTML) 32 Page - M/A-COM Technology Solutions, Inc.

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49

データシートダウンロード