A typical LVDS input connection is shown in

Figure 9. The

media is driven differentially by an LVDS driver. The line is

terminated with a termination resistor equal to the

impedance of the line being driven. The actual resistor

value is media specific, but typically is between 100 and

120

Ω. This resistor should be located close to the

CLC001 inputs pins to minimize the resulting stub length

between the resistor and device pads. The CLC001

common mode range of 0.1V to 2.3V for a 200mV

differential signal.

DS101329-9

FIGURE 9. LVDS, DC-coupled

www.national.com

8