LP8725TLE-CSLASHNOPB datasheet(38/46 Pages) TI1

38 / 46 page

R/W

Slave Address

(7 bits)

'0' A

A P

Control Register Add.

(8 bits)

Data transferred, byte +

Ack

A - ACKNOWLEDGE (SDA Low)

S - START CONDITION

P - STOP CONDITION

From Slave to Master

From Master to Slave

LP8725

SNVS618G – DECEMBER 2009 – REVISED MAY 2013

www.ti.com

•

Master sends control register address (8 bits).

•

Slave sends acknowledge signal.

•

Master device generates repeated start condition.

•

Master sends the slave address (7 bits) and the data direction bit (r/w = “1”).

•

Slave sends acknowledge signal if the slave address is correct.

•

Slave sends data byte from addressed register.

•

If the master device sends acknowledge signal, the control register address will be incremented by one. Slave

device sends data byte from addressed register.

•

Read cycle ends when the master does not generate acknowledge signal after data byte and generates stop

condition.

Address Mode

Data Read

<Slave Address><r/w = ‘0’>[Ack]

<Register Addr.>[Ack]

<Slave Address><r/w = ‘1’>[Ack]

[Register Data]<Ack or NAck>

… additional reads from subsequent register address possible

Data Write

<Slave Address><r/w = ‘0’>[Ack]

<Register Addr.>[Ack]

<Register Data>[Ack]

… additional writes to subsequent register address possible

< > Data from master [ ] Data from slave

Figure 18. Register Write Format

Submit Documentation Feedback

Product Folder Links: LP8725

LP8725TLE-C/NOPB データシート(PDF) 38 Page - Texas Instruments

LP8725TLE-C/NOPB データシート(HTML) 38 Page - Texas Instruments

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46

データシートダウンロード