| データシートサーチシステム |
|
P89LPC932 データシート(PDF) 18 Page - NXP Semiconductors |
|
|
|||||||||||||||||||||||||||||
P89LPC932 データシート(HTML) 18 Page - NXP Semiconductors |
|
18 / 60 page ![]() Philips Semiconductors P89LPC932 8-bit microcontroller with accelerated two-clock 80C51 core Product data Rev. 04 — 06 January 2004 18 of 60 9397 750 12379 © Koninklijke Philips Electronics N.V. 2004. All rights reserved. 8.2.6 Clock output The P89LPC932 supports a user-selectable clock output function on the XTAL2/CLKOUT pin when crystal oscillator is not being used. This condition occurs if another clock source has been selected (on-chip RC oscillator, watchdog oscillator, external clock input on X1) and if the Real-Time clock is not using the crystal oscillator as its clock source. This allows external devices to synchronize to the P89LPC932. This output is enabled by the ENCLK bit in the TRIM register. The frequency of this clock output is 1 ⁄ 2 that of the CCLK. If the clock output is not needed in Idle mode, it may be turned off prior to entering Idle, saving additional power. 8.3 On-chip RC oscillator option The P89LPC932 has a 6-bit TRIM register that can be used to tune the frequency of the RC oscillator. During reset, the TRIM value is initialized to a factory pre-programmed value to adjust the oscillator frequency to 7.373 MHz, ±2.5 %. End-user applications can write to the TRIM register to adjust the on-chip RC oscillator to other frequencies. 8.4 Watchdog oscillator option The watchdog has a separate oscillator which has a frequency of 400 kHz. This oscillator can be used to save power when a high clock frequency is not needed. 8.5 External clock input option In this configuration, the processor clock is derived from an external source driving the XTAL1/P3.1 pin. The rate may be from 0 Hz up to 12 MHz. The XTAL2/P3.0 pin may be used as a standard port pin or a clock output. Fig 6. Block diagram of oscillator control. ÷2 002aaa515 RTC CPU WDT DIVM CCLK UART OSCCLK I2C PCLK TIMER 0 and TIMER 1 High freq. Med. freq. Low freq. XTAL1 XTAL2 RC OSCILLATOR WATCHDOG OSCILLATOR (7.3728 MHz ±2.5%) (400 kHz +20% -30%) PCLK RCCLK SPI CCU 32 × PLL |
|
リンク URL |
| ALLDATASHEETはお客様のビジネスに役立ちますか? [ DONATE ] |
Alldatasheetは | 広告 | お問い合わせ | プライバシーポリシー | データシートへのリンク | リンク交換 | メーカーリスト All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |