2

PS8390

06/04/99

12345678901234567890123456789012123456789012345678901234567890121234567890123456789012345678901212345678901234567890123456789012123456789012

PI5C3384A

10-Bit, 2-Port BusSwitch

Storage Temperature ........................................................... –65°C to +150°C

Ambient Temperature with Power Applied ...........................–40°C to +85°C

Supply Voltage to Ground Potential (Inputs & Vcc Only) .... –0.5V to +7.0V

Supply Voltage to Ground Potential (Outputs & D/O Only) . –0.5V to +7.0V

DC Input Voltage ................................................................... –0.5V to +7.0V

DC Output Current .............................................................................. 120 mA

Power Dissipation ................................................................................... 0.5W

Note:

Stresses greater than those listed under MAXIMUM

RATINGS may cause permanent damage to the

device. This is a stress rating only and functional

operation of the device at these or any other condi-

tions above those indicated in the operational sec-

tions of this specification is not implied. Exposure to

absolute maximum rating conditions for extended

periods may affect reliability.

DC Electrical Characteristics (Over the Operating Range, TA = –40°C to +85°C, VCC = 5V ±5%)

Parameters Description

Min.

Max.

Units

Input HIGH Voltage

Guaranteed Logic HIGH Level

2.0

—

—

V

Input LOW Voltage

Guaranteed Logic LOW Level

–0.5

—

0.8

V

Input HIGH Current

——

±1

µA

Input LOW Current

—

—

±1

µA

High-Impedance Output Current

0

——

±1

µA

Clamp Diode Voltage

—

–0.7

–1.2

V

100

—

—

mA

Input Hysteresis at Control Pins

—

150

—

mV

25

Ω

7

12

Ω

Notes:

1. For Max. or Min. conditions, use appropriate value specified under Electrical Characteristics for the applicable device type.

3. Not more than one output should be shorted at one time. Duration of the test should not exceed one second.

4. Measured by the voltage drop between A and B pin at indicated current through the switch. ON resistance is determined by the

lower of the voltages on the two (A,B) pins.

5. This parameter is determined by device characterization but is not production tested.

Description

Test Conditions

Typ

Units

Input Capacitance

6

pF

A/B Capacitance, Switch Off

9

pF

A/B Capacitance, Switch On

22

pF

Maximum Ratings

(Above which the useful life may be impaired. For user guidelines, not tested.)