SST25PF080B datasheet(16/32 Pages) MICROCHIP

16 / 32 page

SST25PF080B

DS20005137B-page 16

 2014 Microchip Technology Inc.

4.8.5

WRITE-STATUS-REGISTER (WRSR)

The Write-Status-Register instruction writes new val-

ues to the BP2, BP1, BP0, and BPL bits of the status

sequence of the WRSR instruction is entered and

driven high before the WRSR instruction is executed.

See Figure 4-17 for EWSR or WREN and WRSR

instruction sequences.

Executing the Write-Status-Register instruction will be

ignored when WP# is low and BPL bit is set to “1”.

When the WP# is low, the BPL bit can only be set from

“0” to “1” to lock-down the status register, but cannot be

reset from “1” to “0”. When WP# is high, the lock-down

function of the BPL bit is disabled and the BPL, BP0,

BP1, and BP2 bits in the status register can all be

changed. As long as BPL bit is set to 0 or WP# pin is

driven high (VIH) prior to the low-to-high transition of the

CE# pin at the end of the WRSR instruction, the bits in

the status register can all be altered by the WRSR

instruction. In this case, a single WRSR instruction can

set the BPL bit to “1” to lock down the status register as

well as altering the BP0, BP1, and BP2 bits at the same

time. See Table 4-1 for a summary description of WP#

and BPL functions.

FIGURE 4-17:

ENABLE-WRITE-STATUS-REGISTER (EWSR) OR WRITE-ENABLE (WREN) AND

WRITE-STATUS-REGISTER (WRSR) SEQUENCE

25137 EWSR.0

MODE 3

HIGH IMPEDANCE

MODE 0

STATUS

7 65 4321 0

MSB

MODE 3

SCK

CE#

MODE 0

50 or 06

0 1 2 3 4 5 6 7

0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

SST25PF080B データシート(PDF) 16 Page - Microchip Technology

SST25PF080B データシート(HTML) 16 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32

データシートダウンロード