LAN9211 datasheet(140/147 Pages) SMSC

140 / 147 page

High-Performance Small Form Factor Single-Chip Ethernet Controller with HP Auto-MDIX Support

Datasheet

Revision 2.9 (03-01-12)

140

SMSC LAN9211

DATASHEET

7.5

Worst Case Current Consumption

This section details the worst case current consumption for each device power supply. These values

are provided to assist system designers with proper power supply design. These values cannot be

used to determine typical power consumption of the device.

Note: The current measurements listed below were taken under the following conditions:

Temperature: ........................................................................................................................0oC to +70oC

Device VDD:.................................................................................................................. +3.30 V +/- 10%

Note: Current consumption is determined by operating frequency, temperature, and supply voltage,

as well as external source/sink requirements.

Note: Above values do not include the supply current for the magnetics. Based on the recommended

implementation, the maximum supply current needed for the magnetics is 108mA.

Table 7.3 Maximum Supply Current Characteristics

PARAMETER

SUPPLY NAME

MAX

UNITS

NOTES

+3.3V I/O Supply Current

VDD_IO

+3.3V Analog Supply Current

VDD_A33

LAN9211 データシート(PDF) 140 Page - SMSC Corporation