408-6788

8 of 12

Rev L

Figure 12

8.1. To Make 6.35 mm [.250 in.] Bends on RG-402 Cable

or 3.18 mm [.125 in.] Bends on RG-405 Cable

1. Screw the terminated plug onto the dummy jack

of the tool holder. See Figure 15.

2. Slip the appropriate bend segment under the

cable as shown in Figure 15.

3. Using finger pressure, bend the cable around the

segment to the desired angle, to a 90° maximum.

4. Unscrew the plug from the tool holder.

8.2. To Make 3.18mm [.125 in.] Bends on RG-402 Cable

(Figure 16)

1. Make the 6.35mm [.250 in.] radial bend as

described in Paragraph 8.1, and remove the plug

from the tool holder.

2. Replace the 6.35mm [.250 in.] bend segment with

the 3.18 mm [.125 in.] segment for RG-402 cable.

3. Re-attach the plug to the dummy jack of the tool

holder.

4. Place the conforming block over the cable with

the tongue of the block in the slot of the tool holder,

as shown in Figure 16.

5. Insert the limiting pin and slide the block against

the opening.

Figure 13

Plugs with Center Contacts (All Sizes)

Reference

Plane

Cable-Bottoming Plane

4.50 ±0.25 [.177 ±.010]

Right-Angle Plugs

Mating Interface Centerline

Cable-Bottoming Plane

3.76 ±0.25 [.148 ±.010]

Panel Jacks (All Sizes)

Reference

Plane

Cable-Bottoming Plane

6.48 ±0.25 [.259 ±.010]

90° Bend Plug Assemblies

(Plug Applied Before Bending Cable)

Interface

6.35 [.250]

Radius

6.35 [.250]

Radius

Interface

1.57 [.062]

Radius

SMA PLUG TYPE

CABLE

SIZE

DIMENSION

6.35 [.250] RADIUS

3.18 [.125] RADIUS

1.57 [.062] RADIUS

ABAB

AB

Plugs without Center Contact

RG-402

14.68 [.578]

18.11 [.713]

11.51 [.453]

14.94 [.588]

---

---

Plugs without Center Contact

19.18 [.755]

22.61 [.890]

16.00 [.632]

19.43 [.765]

---

---

Plugs with Center Contact

RG-405

---

---

15.34 [.604]

18.75 [.738]

13.72 [.540]

17.14 [.675]

Short Plugs

---

---

12.70 [.500]

15.88 [.625]

11.10 [.437]

14.27 [.562]