ADA4571R-EBZ User Guide

UG-739

GETTING STARTED

SOFTWARE INSTALLATION PROCEDURES

There are two pieces of software to install: the Windows GUI

and the SDP drivers.

Windows GUI Installation

Use the following steps to install the GUI.

1. Before connecting the USB cable or powering the board,

insert the ADA4571-EBZ setup CD and from the installer

directory, run the installer Setup.exe.

2. When the Destination Directory screen appears (see

Figure 2), click Next. Optionally, you may change the

destination folder by clicking Browse, selecting a different

destination folder, and clicking Next.

Figure 2. Choose Destination Location

3. When the Start Installation window appears click Next to

continue with the installation (see Figure 3).

Figure 3. Review Installation

4. Click Next to complete installation of the Windows

LabVIEW GUI.

SDP Installation

Next, install the Analog Devices, Inc., SDP driver. This driver

allows the SDP control board to interface with the LabVIEW

GUI.

1. When the SDP drivers setup wizard appears, click Next

(see Figure 4).

Figure 4. SDP Driver Installation

2. When the Choose Install Location screen appears (see

Figure 5), click Next. Optionally, you may change the

destination folder by clicking Browse, selecting a different

destination folder, and clicking Next.

Figure 5. Choose Install Location

3. Click Finish to complete the installation of the SDP

drivers.

4. Connect the SDP control card to the motherboard and

plug the SDP control card into the PC with the supplied

USB cable. The computer now recognizes the SDP control

board and the LabVIEW GUI may be opened to continue.

Rev. 0 | Page 3 of 13