| データシートサーチシステム |
|
STNS01 データシート(PDF) 8 Page - STMicroelectronics |
|
|
|||||||||||||||||||||||||||||
STNS01 データシート(HTML) 8 Page - STMicroelectronics |
|
8 / 29 page ![]() Electrical characteristics STNS01 8/29 DocID024654 Rev 2 Symbol Parameter Test conditions Min. Typ. Max. Unit V ODCR Battery voltage overdischarge release threshold 3.0 V R ON-IB Input to battery on-resistance 1 1.5 Ω R ON-BS Battery to sys on-resistance I SINK = 100 mA 0.38 0.55 Ω R ON- BATMS BATSNS to BATMS on- resistance I SINK = 500 μA 270 Ω V OL Output low level (CHG) I SINK = 5 mA 0.4 V V IL Logic LOW input level (SD, CEN) V LDO = 3.1 V 0.4 V V IH Logic HIGH input level (SD, CEN) V LDO = 3.1 V 1.6 V R UP CEN pull-up resistor 375 500 625 k Ω R DOWN SD pull-down resistor 375 500 625 k Ω V LDO LDO output voltage I LDO = 1 mA 3.007 3.1 3.193 V V OUT- LOAD LDO static load regulation I LDO = 1 mA to 150 mA ±0.002 %/mA I SC LDO short-circuit current R LOAD = 0 250 350 mA I BATOCP Battery discharge overcurrent protection V IN < V UVLO or V IN > V INOVP (Powered from BAT) 400 650 mA I INLIM Input current limitation V SYS > V ILIMSCTH ; V UVLO < V IN < V INOVP (powered form IN) 1A I INLIMSC Input current limitation in short- circuit conditions V SYS < V ILIMSCTHINOVP (powered form IN) 400 mA V ILIMSCT H SYS voltage threshold for input current limitation short-circuit detection V UVLO < V IN < V INOVP 2V V SCLDO LDO short-circuit protection threshold V IN < V UVLO or V IN > V INOVP (Powered from BAT) 0.7 V V SCSYS SYS short-circuit protection threshold V IN < V UVLO or V IN > V INOVP (Powered from BAT) V BAT -0.8 V I NTCB NTC pin bias current V NTC = 0.25 V 48 50 52 μA V HOT Thermal management hot threshold Increasing NTC temperature 0.234 0.246 0.258 V V COLD Thermal management cold threshold Decreasing NTC temperature 1.28 1.355 1.43 V T HYST Hot/cold temperature threshold hysteresis 10 k NTC, ß = 3370 3 °C T SD Thermal shutdown die temp. 180 °C f FAULT CHG pin blinking frequency Fault condition 1 Hz t CHGD Input voltage connection to charging-start delay V BAT = 3.5V, R NTC = 10 k Ω, battery detection not included (t BDSRC + t BDSNK ) 240 ms Table 6. Electrical characteristics (continued) |
|
リンク URL |
| ALLDATASHEETはお客様のビジネスに役立ちますか? [ DONATE ] |
Alldatasheetは | 広告 | お問い合わせ | プライバシーポリシー | データシートへのリンク | リンク交換 | メーカーリスト All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |