| データシートサーチシステム |
|
TSZ182 データシート(PDF) 28 Page - STMicroelectronics |
|
|
|||||||||||||||||||||||||||||
TSZ182 データシート(HTML) 28 Page - STMicroelectronics |
|
28 / 39 page ![]() Application information TSZ182 28/39 DocID029836 Rev 1 5.12 Phase reversal protection Some op amps can show a phase reversal when the common-mode voltage exceeds the VCC range. Phase reversal is a specific behavior of an op amp where its output reacts as if the inputs were inverted when at least one input is out of the specified common-mode voltage. The TSZ182 has been carefully designed to prevent any output phase reversal. The TSZ182 is a rail-to-rail input op amp, therefore, the common-mode range can extend up to the rails. If the input signal goes above the rail it does not cause any inversion of the output signal as shown in Figure 60: "No phase reversal". If, in the application, the operating common-mode voltage is exceeded please read Section 5.3: "Input pin voltage ranges". Figure 60: No phase reversal |
|
リンク URL |
| ALLDATASHEETはお客様のビジネスに役立ちますか? [ DONATE ] |
Alldatasheetは | 広告 | お問い合わせ | プライバシーポリシー | データシートへのリンク | リンク交換 | メーカーリスト All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |