PD035VX1

The information contained herein is the exclusive property of Prime View International Co., Ltd. and shall not be

distributed, reproduced, or disclosed in whole or in part without prior written permission of Prime View International Co.,

Ltd.

Page:22

14. Handling Cautions

14-1) Mounting of module

a) Please power off the module when you connect the input/output connector.

b) Polarizer which is made of soft material and susceptible to flaw must be handled

carefully.

c) Protective film (Laminator) is applied on surface to protect it against scratches

and dirt. It is recommended to peel off the laminator before use and taking care

of static electricity.

14-2) Precautions in mounting

a) Wipe off water drops or finger grease immediately. Long contact with water may

cause discoloration or spots.

b) TFT-LCD module uses glass which breaks or cracks easily if dropped or bumped

on hard surface. Please handle with care.

c) Since CMOS LSI is used in the module. So take care of static electricity and

earth yourself when handling.

14-3) Others

a) Do not expose the module to direct sunlight or intensive ultraviolet rays for many

hours.

b) Store the module at a room temperature place.

c) The voltage of beginning electric discharge may over the normal voltage because of

leakage current from approach conductor by to draw lump read lead line around.

d) If LCD panel breaks, it is possibly that the liquid crystal escapes from the panel.

Avoid putting it into eyes or mouth. When liquid crystal sticks on hands, clothes or feet.

Wash it out immediately with soap.

e) Observe all other precautionary requirements in handling general electronic components.