over the full operating temperature range. Unless otherwise specified: V

Min/Max limits are guaranteed through testing, statistical correlation, or design. (Continued)

Symbol

Parameter

Conditions

MIN

TYP

(Note 4)

MAX

Units

e

n

Output Noise

BW = 10Hz to 10kHz

V

0.7

µV/

V

Output Leakage Current

V

0.5

12

µA

V

EN

Enable Voltage (LP38692 Only)

Output = OFF

0.4

V

Output = ON, V

1.8

Output = ON, V

3.0

Output = ON, V

4.0

I

EN

Enable Pin Leakage

V

-1

0.001

1

µA

Note 1: Absolute maximum ratings indicate limits beyond which damage to the component may occur. Operating ratings indicate conditions for which the device

is intended to be functional, but do not guarantee specific performance limits. For guaranteed specifications, see Electrical Characteristics. Specifications do not

apply when operating the device outside of its rated operating conditions.

Note 2: At elevated temperatures, device power dissipation must be derated based on package thermal resistance and heatsink values (if a heatsink is used). The

junction-to-ambient thermal resistance (

area (less than 0.1 square inch). If one square inch of copper is used as a heat dissipator for the TO-252, the

package has a

to a copper area of one square inch. The

(refer to application note AN-1187). If power disspation causes the junction temperature to exceed specified limits, the device will go into thermal shutdown.

Note 3: ESD is tested using the human body model which is a 100pF capacitor discharged through a 1.5k resistor into each pin.

Note 4: Typical numbers represent the most likely parametric norm for 25˚C operation.

Note 5: If used in a dual-supply system where the regulator load is returned to a negative supply, the output pin must be diode clamped to ground.

Note 6: Output voltage line regulation is defined as the change in output voltage from nominal value resulting from a change in input voltage.

Note 7: Output voltage load regulation is defined as the change in output voltage from nominal value as the load current increases from 1mA to full load.

Note 8: Dropout voltage is defined as the minimum input to output differential required to maintain the output within 100mV of nominal value.

www.national.com

5