AD7911AUJ-R2 datasheet(20/28 Pages) AD

20 / 28 page

AD7911/AD7921

Rev. 0 | Page 20 of 28

POWER VS. THROUGHPUT RATE

By using the power-down mode on the AD7911/AD7921 when

not converting, the average power consumption of the ADC

decreases at lower throughput rates. Figure 29 shows how, as the

throughput rate is reduced, the device remains in its power-

down state longer and the average power consumption over

time drops accordingly.

For example, if the AD7911/AD7921 are operating in a

continuous sampling mode with a throughput rate of 50 kSPS

and a SCLK of 5 MHz (VDD = 5 V) and the devices are placed in

power-down mode between conversions, then the power

consumption is calculated as follows. The power dissipation

during normal operation is 20 mW (VDD = 5 V). If one dummy

cycle powers up the part between conversions (3.2 µs), and the

remaining conversion time is another cycle (3.2 µs), then the

AD7911/AD7921 dissipate 20 mW for 6.4 µs during each

conversion cycle. If the throughput rate is 50 kSPS and the cycle

time is 20 µs, then the average power dissipated during each

cycle is

(6.4/20) × (20 mW) = 6.4 mW

If VDD = 3 V, SCLK= 5 MHz, and the device is again in power-

down mode between conversions, then the power dissipation

during normal operation is 6 mW. The AD7911/AD7921 now

dissipate 6 mW for 6.4 µs during each conversion cycle. With a

throughput rate of 50 kSPS, the average power dissipated during

each cycle is

(6.4/20) × (6 mW) = 1.92 mW

In the previous examples, the power dissipation when the part is

in power-down mode has not been taken into account, because

the shutdown current is so low that it does not have any effect

on the overall power dissipation value. Figure 29 shows the

power consumption versus throughput rate when using the

power-down mode between conversions with both 5 V and 3 V

supplies.

Power-down mode is intended for use with throughput rates of

approximately 120 kSPS and under, because higher sampling

rates do not have a power saving in power-down mode.

0.01

100

0.1

135

120

105

THROUGHPUT (kSPS)

VDD = 5V, SCLK = 5MHz

VDD = 3V, SCLK = 5MHz

Figure 29. Power Consumption vs. Throughput Rate

AD7911AUJ-R2 データシート(PDF) 20 Page - Analog Devices

AD7911AUJ-R2 データシート(HTML) 20 Page - Analog Devices

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28

データシートダウンロード