Introduction
The 68HC908EY16 is a member of the low-cost, high-performance M68HC08 Family of 8-bit microcontroller units (MCUs). All MCUs in the family use the enhanced M68HC08 central processor unit (CPU08) and are available with a variety of modules, memory sizes and types, and package types.

Features
For convenience, features have been organized to reflect:
• Standard features of the 68HC908EY16
• Features of the CPU08

Standard features of the MC68HC908EY16 include:
• High-performance M68HC08 architecture optimized for C-compilers
• Fully upward-compatible object code with M6805, M146805, and M68HC05 Families
• 8-MHz internal bus frequency at 5V
• Internal oscillator requiring no external components:
   – Software selectable bus frequencies
   – 25 percent accuracy with trim capability to 2 percent
   – Clock monitor
   – Option to allow use of external clock source or external crystal/ceramic resonator
• 15,872 bytes of on-chip FLASH memory with in-circuit programming
• FLASH program memory security1
• 512 bytes of on-chip random-access memory (RAM)
• Low voltage inhibit (LVI) module
• Internal clock generator module (ICG)
• Two 16-bit, 2-channel timer (TIMA and TIMB) interface modules with selectable input capture, output compare, and pulse-width modulation (PWM) capability on each channel
• 8-channel, 10-bit successive approximation analog-to-digital converter (ADC)
• Enhanced serial communications interface module (ESCI) for local interconnect network (LIN) connectivity
• Serial peripheral interface (SPI)
• Timebase Module (TBM)
• 5-bit keyboard interrupt (KBI) with wakeup feature
• 24 general-purpose input/output (I/O) pins
• External asynchronous interrupt pin with internal pullup (IRQ)
• System protection features:
   – Optional computer operating properly (COP) reset
   – Illegal opcode detection with reset
   – Illegal address detection with reset
• 32-pin quad flat pack (QFP) package
• Low-power design; fully static with stop and wait modes
• Internal pullups on IRQ and RST to reduce customer system cost
• Standard low-power modes of operation:
   – Wait mode
   – Stop mode
• Master reset pin (RST) and power-on reset (POR)
• BREAK module (BRK) to allow single breakpoint setting during in-circuit debugging
• Higher current source capability on nine port lines for LED drive (PTA6/SS, PTA5/SPSCK, PTA4/KDB4, PTA3/KBD3, PTA2/KBD2, PTA1/KBD1, PTA0/KBD0, PTC1/MOSI, and PTC0/MISO)

Features of the CPU08 include:
• Enhanced HC05 programming model
• Extensive loop control functions
• 16 addressing modes (eight more than the HC05)
• 16-bit index register and stack pointer
• Memory-to-memory data transfers
• Fast 8 × 8 multiply instruction
• Fast 16 ÷ 8 divide instruction
• Binary-coded decimal (BCD) instructions
• Optimization for controller applications
• Third party C language support