AD9577BCPZ-R7 datasheet(37/44 Pages) AD

37 / 44 page

Data Sheet

AD9577

Rev. A | Page 37 of 44

MAX_BW

The normal bandwidth of PLL2 is 50 kHz. This low bandwidth

is required to filter the SDM phase noise. When SSCG is activated,

the bandwidth is increased to 125 kHz. There is a trade-off in

setting the PLL bandwidth between allowing the triangular-wave

modulation (that is, its higher order harmonics) to pass through

the PLL unattenuated and passing more SDM phase noise through

to the PLL output. Bringing the MAX_BW pin high changes the

PLL bandwidth to 250 kHz from its default value of 125 kHz

during SSCG operation. Increasing the PLL bandwidth results

in more SDM phase noise being passed unfiltered through to the

PLL output, but more of the triangular-wave harmonics are also

passed through, improving the triangular-wave accuracy.

Table 29. Register Values for SSCG Example

Parameter

Range

Value (Decimal)

Value(Binary)

NumSteps

BS2[7:0], BS3[7]

+1 to +511

+45

00101101

FracStep

BS1[7:0]

−128 to 0

−7

11111001

CkDiv

BS3[6:0]

+2 to +127

0001001

FRAC

BF0[7:0], BF1[7:4]

0 to +4094

+198

000011000110

MOD

BF1[3:0], BF2[7:0]

0 to +4095

+625

001001110001

BF3[5:0]

0 to +63

80 + 20 = 100

010100

AD9577BCPZ-R7 データシート(PDF) 37 Page - Analog Devices

AD9577BCPZ-R7 データシート(HTML) 37 Page - Analog Devices

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44

データシートダウンロード